CEMENTITIOUS SELF LEVELING VFLOOR1

CEMENTITIOUS SELF LEVELING VFLOOR1

5KGS / BARREL: 100.000 VND (CAN BE FINISHED 1 M² / 2MM THICK)

COMBO (BARREL 20KGS + PRIMER) : 450.000 VND 

NOTE: 

- THE THINNEST THICKNESS IS 2 MM

- MUST BE PRIMED BEFORE POURING TO AVOID BLISTERING

PRODUCT PICTURES

Description:

VFLOOR1 is a single component Cementitious Self Leveling Mortar. Once cured, it provides a smooth, level surface on which to install a variety of floor coverings.

Suitable for prepairing interior floors prior to laying parquet, vinyl sheet and tile, soft floor covering, natural stone, ceramic tiles, etc…

It can be used on a wide range of absorbent and non-absorbent floor surfaces including concrete, cement and sand screeds, terrazzo, asphalt, ceramic & quarry tiles.

Layer-thickness 2-10mm

Can be pumped

Standard primers give excellent bonding to the VFLOOR1 products

Product name	VFLOOR1
Compressive strength	>40 Mpa, 28 days later
Flexural strength	>8 Mpa, 28 days later
Application temperature	5-30 degree
Mixing ratio	20kgs powder + 5.2kgs Liquid
Product name	PRIMER
Mixing ratio	2kgs Primer + 2L water + 4kgs cement

Feature & Benefits:

• Single component, just mix with water
• Good adhesion to primed substrates
• Good flow, self smoothing
• Rapid setting and early strength
• Easy and quick to lay

Installation System:

 

Direction for use:

Mixing:

Add clean water to suitable mixing bucket. Mix slowly and continuously to form a homogeneous mixture.

• VFLOOR1 20kgs barrel required approximately 5.2 litres of clean water
• VFLOOR1 5kgs barrel required approximately 1.3 litres of clean water

The mixed materials is immediately ready to use and should be used within 30-40 minutes after mixing.

Ready for foot traffic after approx. 3 hours.

Laying:

Pour the mixed material onto the floor immediately after mixing and spread with wide sweeping strokes using a plaster’s plastic or steel float.

Use firm pressure and work well into the corners and around projections.

Leave a neat edge for subsequent batches.

Subsequent mixes should be poured into the wet edges of the previous mix.

Old partially set material must be scraped and discarded

Hardening:

Full strength is achieved after 28 days. At 28ºC room temperature, VFLOOR1 will be sufficiently dry to allow adhesive spreading after 48 hours.

This will take longer in colder climatic conditions. Do not lay in temperature below 5ºC

Under floor heating must be turned off at least 48 hours before work starts and left off until 48 hours after the final surfacing has been completed.

Drying time:

Prevent draughts across the floor to avoid localized premature drying

At ambient temperature, VFLOOR1 will appear to be dry after approximately 24 hours.

Floor laying may commence after 48 hours.

Safety Data:

As with all chemical products, care should be taken during use and storage to avoid contact with eye, mouth, skin and foodstuff (which can also be tainted with vapour until the product is fully cured or dried)

User Notes:

The technical details and recommendations contained in this data sheet are given in good faith and represent the best of our knowledge and experience at time of printing. It is the responsibility of the user to ensure that the products are used in accordance with VFLOOR1 instruction.

Construction:

Coverage:

• At an application thickness of 2mm the coverage will be approx. 5-6 m² per 20kgs
• At an application thickness of 2mm the coverage will be approx. 1-1.5 m² per 5kgs

Shelf Life:

18 months.