SELF LEVELING CONCRETE WITHOUT PRIMER VFLOOR2

SELF LEVELING CONCRETE WITHOUT PRIMER VFLOOR2

SET 25KGS : 377.000 VND (CAN BE FINISHED 6 M² / 2MM THICK)

BARREL 20KGS + PRIMER 2KGS : 340.000 VND 

NOTE: THE THINNEST THICKNESS IS 2 MM

PRODUCT PICTURES 

Description:

VFLOOR2 are two component waterproof Self Leveling Mortar. Once cured, it provides a smooth, level surface on which to install a variety of floor coverings. Suitable for prepairing interior floors prior to laying parquet, vinyl sheet and tile, soft floor covering, natural stone, ceramic tiles, etc…

It can be used on a wide range of absorbent and non-absorbent floor surfaces including concrete, cement and sand screeds, terrazzo, asphalt, ceramic & quarry tiles.

Layer-thickness 2-10mm

Can be pumped

Product name	Self leveling concrete without primer VFLOOR2
Compressive strength	>35 Mpa, 28 days later
Flexural strength	>7 Mpa, 28 days later
Application Temperature	5-30 degree
Mixing ratio	20kgs powder + 5kgs Liquid

Feature & Benefits:

• Two component, just mix A+B
• Waterproofing
• Good adhesion to primed substrates
• Good flow, self smoothing
• Rapid setting and early strength
• Easy and quick to lay

Installation System:

 

Direction for use:

Mixing:

Convenient easy mix ratio A:B = 4:1 by mass. Mix slowly and continuously to form a homogeneous mixture.

The mixed materials is immediately ready to use and should be used within 30-40 minutes after mixing.

Ready for foot traffic after approx. 24 hours.

Laying:

Pour the mixed material onto the floor immediately after mixing and spread with wide sweeping strokes using a plaster’s plastic or steel float.

Use firm pressure and work well into the corners and around projections.

Leave a neat edge for subsequent batches.

Subsequent mixes should be poured into the wet edges of the previous mix.

Old partially set material must be scraped and discarded

Hardening:

Full strength is achieved after 28 days. At 28ºC room temperature, VFLOOR2 will be sufficiently dry to allow adhesive spreading after 48 hours.

This will take longer in colder climatic conditions. Do not lay in temperature below 5ºC

Under floor heating must be turned off at least 48 hours before work starts and left off until 48 hours after the final surfacing has been completed.

Drying time:

Prevent draughts across the floor to avoid localized premature drying

At ambient temperature, VFLOOR2 will appear to be dry after approximately 24 hours, ready for foot traffic after approx. 24 hours.

Floor laying may commence after 48 hours.

Safety Data:

As with all chemical products, care should be taken during use and storage to avoid contact with eye, mouth, skin and foodstuff (which can also be tainted with vapour until the product is fully cured or dried)

User Notes:

The technical details and recommendations contained in this data sheet are given in good faith and represent the best of our knowledge and experience at time of printing. It is the responsibility of the user to ensure that the products are used in accordance with VFLOOR2 instruction.

Construction:

Coverage:

At an application thickness of 2mm the coverage will be approx. 5-6 m² per 25kgs

Shelf Life:

18 months.